How do I program the channels for a Uniden scanner?

SOURCE: Uniden Bearcat Scanner Model# BC147XLT

The BC147XLT is too old to obtain a manual from Uniden, but here's how you program it:

Turn it on & press 'Manual', then enter the number of the channel you wish to program & press 'Manual' again. Now enter the frequency you want to put in that channel, example 155.550, and press "Enter'. Then press manual to go to the next channel or repeat the first procedure to select a different channel other than the next one. Repeat the programming procedure for each channel.

SOURCE: Programming a scanner

To program a BC 70XLT turn the scanner on and hit the man key.
enter the channel you want to program (ie 1) hit the man key again then enter the frequency you want to scan (IE 450.625) then hit the E key to enter the freq into the location if you want to sequence to the next channel then hit the man key again enter the freq and hit the E key.you can go through all 20 channels this way.

SOURCE: lost book to scanner its

do you have a button marked "prgm"
if not, then push the manual button until it
gets to the channel you want to program,
then enter the freq ie... 155.xxx and hit
enter, don't forget the decimal point .

http://www.uniden.com/index/manuals_results.cfm?cat=3

heres a link to uniden bearcat manuals , but i don't see yours .
but my instructions will get the job done .

SOURCE: I have a uniden ubc73xlt handheld scanner,can't

Try a master rest:
If the scanner's display locks up or stops operating
properly, you might need to reset the scanner.
Caution: This procedure clears all the information
you have stored in the scanner. Before you reset the
scanner, try turning it off and on to see if it begins
working properly. Reset the scanner only when you
are sure it is not working properly.
1. Turn off the scanner.
2. While holding down 2, 9, and Hold, turn on the
scanner. It takes about 3 seconds to initialize
and CLEAR appears.

SOURCE: how to program and delete uniden bearcat scanner 210 XWneed to c

I can't locate information specific to the 210XW, but hopefully this generic Bearcat programming info will help:

1. Press the MANUAL key to advance to the channel that you wish to reprogram.

2. Enter the new frequency, including decimal point.

3. Press the ENTER or E key.

4. Start over with step one to continue programming channels.