C 41 hi i have a problem in toshiba cope all the time no work and c 41

If 1st time occur, u can just go to 08-400, reset the value to "0" then restart the machine.






When this code not cleat 08-400 then check these all thengs..
1.Check the thermistors
(1) Check if the connectors are disconnected.
(2) Check if the main and edge thermistors are in contact with the surface of the fuser roller properly?
(3) Check if the harnesses of the main and edge thermistors are open circuited.


2. Check the IH board and IH coil


(1) Check if the IH coil is broken.
(2) Check if the connector of the IH coil is disconnected.
(3) Check if the thermostat is blown.
(4) Check if the connectors on the IH board are disconnected (AC input connector and LGC I/F connector
CN455/456).
(5) Check if the IH board or the switching power supply unit are abnormal.
• Replace the IH control board.


3. Check the LGC board
(1) Check if the connectors CN316 are disconnected.
(2) Check if the conductor pattern on the LGC board is short circuited or open circuited.
(3) Replace the LGC board.


Thanks
Best Regards

A 2060 toshiba photocopier have a problem of not printing, wat is the solution

Try replacing the thermal fuse in the fuser. Then reset your C41 by using the "08" mode, code 89, reset to 0. If that doesn't work, replace the thermistor and do the same procedure again.

.press and hold 08 while turning on the copier reset your C41 by using the "08" mode, code 89, press start key change the figure coming on the display to 0 then press interrupt key then off and on the machine,If that doesn't work, replace the thermistor and do the samTry replacing the thermal fuse in the fusere procedure again