Questions & Answers for: fork alignment - Page 2

Question about 1996 XR 600 R

1 Answer

...from the handle bars with the triple clamps square to the frame the tire veirs to the right. The forks are not leaking oil. When you look from the right side of the bike it looks as though the ...

Ad

Question about 1986 GV 1400 Cavalcade LX

1 Answer

...whats going on? Could be bad wheel bearings, loose steering stem, bad steering stem bearings, forks not balanced (unequal fluid in the two forks), Forks out of alignment, low tire pressure and ...

Ad

...fork. bang away until it's free. Rotating it off the shaft may take some time depending on corrosion. You'll need an alignment when your done. If you at least thread the new tie rod on to exactly ...

How do I put front wheel on without making the forks lock up it keeps doing that when I put it on my02 cr250 Putting uneven loading on the forks(twist) may cause binding and harsh action but I haven't

Question about 2002 CR 250 R

2 Answers

i just bought the bike , and have just noticed the front fork is bent , it looks like the left fork bends foward about an inch , is this normal Bent forks are not normal, most likely got damaged in ...

Question about 2002 CR 250 R

1 Answer

...the wheel. Where you inserted the handle bars into the bearing assembly on the frame there is a fork clamp you had to tighten to secure the handle bars and front fork. Loosen this and you should ...

Question about 1998 R 1100 R

1 Answer

...8,000 miles and has never been dropped. Any advise before I sell it? Check the bolts that hold your forks in place, if they are tight, loosen the middle bolts that hold the forks and give the front ...

Question about 1998 R 1100 R

1 Answer

...fork should be the same on both sides. When in proper position (aligned) tighten the axle bolts, making sure that the wheel doesn't go out of alignment when tightening.Also, make sure , while ...

throw out barring fork doesnot allignment with clutch slave fork too short Did it pop out of position or what? Or was this after you replaced the clutch or what? Well on clutch forks ive seen. There ...

...fork alignment with marker pen undo retaining clamps on yokes if your forks are upside down ones then undo top cover s then there should be a bolt that holds the inner leg to the fork sleeve once u ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

73783 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7373 Answers

ADMIN Eric
ADMIN Eric

Level 3 Expert

42221 Answers

Are you a Motorcycles Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...