Anonymous posted an answer for this 1996 Jeep Grand Cherokee:
"If the trans fluid isn't low. Then check for a burnt smell...either way ur trans is going..."
Anonymous posted an answer for this 1996 Jeep Grand Cherokee:
"1996 jeep grand cherokee limited the thing runs like a champ it is just slipping in..."
Anonymous posted an answer for this 2008 Jeep Patriot:
"While shipping the vehicle they may have unhooked something underneath from the..."
Anonymous posted an answer for this 2008 Jeep Patriot:
"Hi, I have a problem with jeep patriot 2010 model. When I bought from singapore dealer and..."
Anonymous posted an answer for this 1994 Ford Escort:
"On the steering column. Either the top or side. Hope This helps !"
Anonymous posted an answer for this 2002 Nissan Xterra:
"I would like to know if all the exterior plastic parts that had been faded off can be..."
Anonymous posted an answer for this 2002 Nissan Xterra:
"Yes. Both. If they are black might I suggest Turtle Wax Wet n' Black Ultra Wet Tire Shine...."
Anonymous posted an answer for this 2005 Ford Freestar:
"There is air in the brake system and must be bled. They have devices for bleeding the..."
Anonymous posted an answer for this 2005 Ford Freestar:
"hi i just changed my calipers on my 2005 ford freestar and my brakes are not working is..."
Anonymous posted an answer for this 2004 Chrysler Sebring:
"Distributor caps can have a poor connection or corrosion causing misfires or a poor idle...."
Anonymous posted an answer for this 2004 Chrysler Sebring:
"the engine turns over but does not start... the fuel is being pumped in.... how do I tell..."
Anonymous posted an answer for this 1996 Chevrolet Beretta:
"I would buy a chilton or Haynes manual from my local auto parts for approx. $22.00 as they..."
Anonymous posted an answer for this 1996 Chevrolet Beretta:
"What is a good resource for replacing spark plugs and wires for a 1996 Chevy Beretta. I'm..."
Anonymous posted an answer for this 2004 Mazda MPV:
"Is the abs light on when you turn the key to run ? If not then the bulb is blown or..."
Anonymous posted an answer for this 2004 Mazda MPV:
"ABS indicator is not on, but there is no "grinding" sound of ABS when braking on..."
Anonymous posted an answer for this 1997 Ford Explorer AWD:
"There should be "push pins" into the plastic housing or an access door. They don't make..."
Anonymous posted an answer for this 1995 Jeep Grand Cherokee:
"It is located on the heater box. Can be inside cabin or underhood. But it's def in the big..."
Anonymous posted an answer for this 1995 Jeep Grand Cherokee:
"'95 Jeep Grand Cherokee Laredo...Blower motor speed control resistor out. Only blows on..."
Anonymous posted an answer for this 2001 Mitsubishi Eclipse:
"Well short of swapping dashes about the only thing a person can do is get a dash mat. Hope..."
Anonymous posted an answer for this 2001 Mitsubishi Eclipse:
"dash is cracked"
Anonymous posted an answer for this 1997 Land Rover Range Rover:
"Have you checked your blower motor resistor and the common reason that the motor or..."
Anonymous posted an answer for this 1997 Land Rover Range Rover:
"my blower motor is not comming on at all even after i replaced it i have p38 1998 ."
Anonymous posted an answer for this 2001 Pontiac Bonneville:
"It's either located by the harmonic balancer or flywheel. Usually small and exposed has a..."
Anonymous posted an answer for this 2001 Pontiac Bonneville:
"changing crankshaft sensor"
Anonymous posted an answer for this Nissan Cars & Trucks:
"There should be a sticker under the hood which shows the route of the belt and the..."
Anonymous posted an answer for this Nissan Cars & Trucks:
"changing serpeanteen belt on 2005 Nissan Altima 2.5, where is the tension pulley"
Anonymous posted an answer for this 2004 Chevrolet Silverado 2500HD:
"It's located along the drivers side frame rail between the tank and engine. Hope this..."
Anonymous posted an answer for this 2004 Chevrolet Silverado 2500HD:
"Where is the fuel filter located"
Anonymous posted an answer for this 2005 Nissan 350Z:
"If it's digital there's a button somewhere I'm sure. However if it's a printed read out,..."
Cars & Trucks 20 answers
Cycling 1 answer