1
Anonymous posted an answer for this 2003 Nissan Pathfinder:
"front wipers not moving after heavy snow woper blades disconnected from motor where is the..."
AnonymousAnonymous posted an answer for this 2003 Nissan Pathfinder:
"the pivot point for the blades are connected to connection rods, usually under the hood or..."
Anonymous
Anonymous posted an answer for this 1998 Pontiac Bonneville:
"heater fan quit working checked fuses and they are ok....a month ago it happened and when..."
AnonymousAnonymous posted an answer for this 1998 Pontiac Bonneville:
"It may be that the motor is failing. Other things to check is connections to the motor..."
Anonymous
Anonymous posted an answer for this Chevrolet Cars & Trucks:
"The wiring is disconnected, the sending unit is not functioning are my first two guesses."
AnonymousAnonymous posted an answer for this Chevrolet Cars & Trucks:
"Temp guage quite working, what could be some of the problems"
Anonymous
Anonymous posted an answer for this 2003 Kia Spectra:
"no taillights and headlights blow."
AnonymousAnonymous posted an answer for this 2003 Kia Spectra:
"No taillights and the headligts blow the fuse when turn on would indicate that there is a..."
Anonymous
Anonymous posted an answer for this 2000 Mercury Cougar:
"My first suspicion is the battery connections may be lose and also the battery may now be..."
AnonymousAnonymous posted an answer for this 2000 Mercury Cougar:
"My mercury cougar won't start, battery looks ok, everything is working fine but if I try..."
Anonymous
Anonymous posted an answer for this 2004 Suzuki Verona:
"The default is off so each time the vehicle is turned off, it goes to off. You need to..."
AnonymousAnonymous posted an answer for this 2004 Suzuki Verona:
"how can I tell when the traction control is on. I push the TCS button and the TCS light..."
AnonymousAnonymous posted an answer for this 1996 Mercury Grand Marquis:
"My cigarette light does not work. I checked for power.. none at all. checked fuse. the..."
Anonymous
Anonymous posted an answer for this 1996 Chevrolet Cavalier:
"You can put it all of the pulleys, including the "tensioner" pulley except one that is..."
Anonymous
Anonymous posted an answer for this 2000 Ford Expedition:
"One hose takes the fluid into the core and one takes it out. Find them, disconnect them..."
Anonymous
Anonymous posted an answer for this 2004 Toyota Corolla:
"The slow turning of the engine indicates the battery is getting week. Gradually get so..."
Anonymous
Anonymous posted an answer for this 1988 Toyota MR2:
"The clutch pedal may be connect to the clutch with a cable that is broken and if it was a..."
AnonymousAnonymous posted an answer for this 2002 Ford Escort:
"I'm not particularly familiar with that vehicle but all that I have seen also have a valve..."
Anonymous
Anonymous posted an answer for this 2005 Nissan Altima:
"The rear brakes engage when the power or pressure going through the lines are equal. ..."
AnonymousAnonymous posted an answer for this 1989 Volvo 740:
"Check for a blown fuse and if you find it then you need to answer the question as to why..."
Anonymous
Anonymous posted an answer for this 2000 Dodge Durango:
"likely the upper ball joint, but could also be the structure that holds the joint."
Anonymous
Anonymous posted an answer for this 2005 GMC Yukon:
"The speedo in electronic and can have various circuit board problems. I've had to cars..."
Anonymous
Anonymous posted an answer for this 1990 Mazda B-Series:
"No, that is not normal. Do you have rear drums? if they are too far out of adjustment that..."
Anonymous
Anonymous posted an answer for this Powermatic 66 10" 3 HP 1 Phase 230V Table Saw w/ 30" Accu-Fence & Rout-R-Lift 1660806K:
"I also bought a used Powermatic 66 however mine in the 5 hp. The dial in my switch box and..."
AnonymousAnonymous posted a question about Powermatic 66 10" 3 HP 1 Phase 230V Table Saw w/ 30" Accu-Fence & Rout-R-Lift 1660806K:
"I started and used my powermatic 66 5 hp saw as usual until I pushed to "off" button and..."
Anonymous
Anonymous posted a question about Chicago Pneumatic 1/2" Air Impact Wrench:
"My CP 734 has no power under load. Is there a rebuild kit to fix this problem and where..."
Anonymous
Cars & Trucks 17 answers
Saws 1 answer
