2
Anonymous posted an answer for this 2005 Ford Focus:
"the low side port is under the rf fender on the accumul;ator.\ you have to lay down and..."
AnonymousAnonymous posted an answer for this 2005 Ford Focus:
"where is access ports for Air Conditioning ?"
Anonymous
Anonymous posted an answer for this 2000 Ford Escort:
"if it is a 2000 escort 2-door zx2 then yes it has a zetec engine dual over head cam 2.0"
AnonymousAnonymous posted an answer for this 2000 Ford Escort:
"2000 ford escort zx2 engine number 0g-774-aa. Is this a Zetec engine?"
Anonymous
Anonymous posted an answer for this 2003 Ford Taurus:
"24 valve engine check engine light comes on saya motor running to lean"
AnonymousAnonymous posted an answer for this 2003 Ford Taurus:
"there is an elbow under the throttle body area that is the pcv line. it will get soft and..."
Anonymous
Anonymous posted an answer for this Ford Cars & Trucks:
"probably both banks are running lean it just hasnt flagged a code for bank2 yet. sounds..."
AnonymousAnonymous posted an answer for this Ford Cars & Trucks:
"98 windstar 3.8litre runs very rough at low revs. error message #1 bank running lean. have..."
Anonymous
Anonymous posted an answer for this 2003 Ford Focus:
"2003 Ford Focus 2.0 L engine. The battery is dead. I put a new battery in and the battery..."
AnonymousAnonymous posted an answer for this 2003 Ford Focus:
"you may need a new alternator.' have some one at your local parts stoore use a voltmeter..."
Anonymous
Anonymous posted an answer for this 2005 Ford Mustang:
"the wrench light means there is-or-was a problem with the elctronic throttle control. the..."
AnonymousAnonymous posted an answer for this 2005 Ford Mustang:
"I have a 2005 ford mustang and i am on a trip to arkansas.two different lights came on.one..."
Anonymous
Anonymous posted an answer for this 1999 Ford Windstar:
"if the front ac works well but the rear is hot check to rear control switch located in the..."
AnonymousAnonymous posted an answer for this 1999 Ford Windstar:
"no rear air but blows good"
Anonymous
Anonymous posted an answer for this 2003 Ford Windstar:
"how to change ignition coil pack on 2003 ford windstar where is it located"
AnonymousAnonymous posted an answer for this 2003 Ford Windstar:
"the coil pack is located on nthe back valve cover, bank1, towards the firewall. it mounts..."
AnonymousAnonymous posted an answer for this Ford Cars & Trucks:
"its on the accumulator, between the battery and engine on the firewall. it is ussually..."
AnonymousAnonymous posted an answer for this Ford Cars & Trucks:
"where is the low end port to recharge the ac in a 2001 F150"
Anonymous
Anonymous posted an answer for this 1995 Ford Escort:
"on this model you need to inspect the blower resistor and connector, a poor connection at..."
AnonymousAnonymous posted an answer for this 1995 Ford Escort:
"I replace the blower fan in my 1998 Ford Escort SE sedan becuase the old motor was shot...."
Anonymous
Anonymous posted an answer for this 2003 Ford Escort:
"without knowing a symptom, all i can say is with a scan tool you can monitor the hz..."
AnonymousAnonymous posted an answer for this 2003 Ford Escort:
"How do I know if my mass air flow is bad"
Anonymous
Anonymous posted an answer for this 1995 Ford Contour:
"ussually when it goes bad on your engine 2.0l zetec. its because the idler pulley(s)..."
AnonymousAnonymous posted an answer for this 1995 Ford Contour:
"how do i know when the timing belt is goin out?"
Anonymous
Anonymous posted an answer for this 1994 Ford Crown Victoria:
"if it sounds kind of grinding the regulator is bad, it is cable driven and whenit goes bad..."
AnonymousAnonymous posted an answer for this 1994 Ford Crown Victoria:
"1994 Ford Crown Victoria power front window will not go up or down but I can still hear..."
Anonymous
Anonymous posted an answer for this 2004 Ford Taurus:
"i removed the compressor. there is an 8 mm bolt that holds the hub on. remove the bolt and..."
AnonymousAnonymous posted an answer for this 2004 Ford Taurus:
"how to install a clutch pulley for the compressor"
Anonymous
Anonymous posted an answer for this 1992 Ford Taurus:
"the tensioner has a 15mm bolt that you can use a wrench on, the longer the wrench the..."
AnonymousAnonymous posted an answer for this 1992 Ford Taurus:
"i'm trying to compress a belt tensioner on a 3.8 ltr, what do i use?"
Anonymous
Cars & Trucks 45 answers
