1
Anonymous posted a question about Ford Cars & Trucks:
"I have a 1991 ford ranger 2.3 2wd that starts, runs, and drives great, but just dies..."
Anonymous
Anonymous posted an answer for this 2002 Dodge Stratus:
"I lost my key how much is a new one for a 2000 dodge stratus 2.4?"
AnonymousAnonymous posted an answer for this 2002 Dodge Stratus:
"The key costs about 10 bucks, but the shop labor to program it is 1hr. which is about $90"
Anonymous
Anonymous posted an answer for this 1999 Dodge Intrepid:
"I need to know how the belt tensioner works and how do I change the power steering and..."
AnonymousAnonymous posted an answer for this 1999 Dodge Intrepid:
"there is a pulley that the belt goes around that has a square hole in it. A 3/8's ratchet..."
Anonymous
Anonymous posted an answer for this 2002 Suzuki XL-7:
"how do i turn the service engine light off on a 2002 xl7"
AnonymousAnonymous posted an answer for this 2002 Suzuki XL-7:
"Dissconnect the positve cable from the battery for 1 min. It will reset the system. If it..."
Anonymous
Anonymous posted an answer for this 1996 Ford Taurus:
"You have to buy a special tool, Ford Fuel Filter Removal tool. The filter is located on..."
AnonymousAnonymous posted an answer for this 1996 Ford Taurus:
"need to change fuel filter"
Anonymous
Anonymous posted an answer for this 2002 Ford ZX2:
"It has most likely wiggled loose out of the transmission, it would be unlikely that it..."
AnonymousAnonymous posted an answer for this 2002 Ford ZX2:
"the speedometer doesnt work"
Anonymous
Anonymous posted an answer for this 1998 Ford Explorer:
"You have to remove one of the valve covers, If i remember correctly, its the passenger sid"
AnonymousAnonymous posted an answer for this 1998 Ford Explorer:
"how do u remove the intake plenum."
Anonymous
Anonymous posted an answer for this 1997 Mercury Sable:
"Either your battery has too little cold cranking amps for your car, or the battery is just..."
AnonymousAnonymous posted an answer for this 1997 Mercury Sable:
"poor cold weather starting"
Anonymous
Anonymous posted an answer for this 1994 Ford Probe:
"The headlight switch is called a multi-function switch. That is the problem, its going..."
AnonymousAnonymous posted an answer for this 1994 Ford Probe:
"1989 PROBE GT. The headlight doors open and close on their own constantly without the..."
Anonymous
Anonymous posted an answer for this 2006 Pontiac G6:
"my remote won't work of my pontiac G6 2008 what can i do my self i already replaced the..."
AnonymousAnonymous posted an answer for this 2006 Pontiac G6:
"Depending on how long the battery was out of the remote, you may have to re-sync it to the..."
Anonymous
Anonymous posted an answer for this 1995 Oldsmobile Achieva:
"What's the oil capacity for a 1995 Olds Achiva? I believe it's a 6 cylinder. Need to do an..."
AnonymousAnonymous posted an answer for this 1995 Oldsmobile Achieva:
"Start at 5qts. It should take 5 1/2, Put 5 in, start it, let it run for 30 seconds, to..."
AnonymousAnonymous posted an answer for this 1989 Mazda B-Series:
"I need to replace a Master Brake Cylinder for a 1989 Mazda B2200 truck."
AnonymousAnonymous posted an answer for this 1989 Mazda B-Series:
"whats the problem?"
AnonymousAnonymous posted an answer for this 1996 Ford Taurus:
"Where is the fuse for cruise control"
AnonymousAnonymous posted an answer for this 1996 Ford Taurus:
"Its a 15A fuse, #19"
Anonymous
Anonymous posted a question about 1998 Plymouth Breeze:
"won't start normally, and when it does it will just die driving. i think its the cam..."
AnonymousAnonymous posted an answer for this 2002 Ford ZX2:
"try the temp sending unit, should be located on the thermostat houseing"
AnonymousAnonymous posted an answer for this 1987 Ford Ranger:
"stop shifting so hard. your reverse gear is the same exact gear as your first, so if you..."
Anonymous
Anonymous posted an answer for this 1998 Ford Escort:
"take a pry bar to the side of the tranny and pry the cv out, there is a clip on the shaft..."
AnonymousAnonymous posted an answer for this 2005 Ford Lincoln Continental:
"yeah, not happening dude"
AnonymousAnonymous posted an answer for this 1987 Ford Ranger:
"grind out the mounts on the body until you hit actual metal and weld some steel on it and..."
Anonymous
Cars & Trucks 29 answers
