Flotec Logo

Flotec Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 156 Products
  • 491 Answers
  • 73K Views
0helpful
2answers

I cannot get my new Flotec 4012-10 well pump to prime or pump water

Even new pumps have faulty parts. It could be that the foot valve is defective.
4/20/2026 11:22:14 AM • Flotec Plumbing • Answered on Apr 20, 2026
0helpful
1answer

Pentax CAM 100 Water Pump. How to remove Pentax Cam 100 hood impeller please?

Question edited for clarity. Question moved from Pentax camera to well pumps. Old Question but Help here https://www.google.com/search?q=pentax+cam100+pump+remove+hood+impeller+cover ..
7/29/2024 5:26:20 PM • Flotec Corrosion... • Answered on Jul 29, 2024
0helpful
2answers

My flotech pool pump stops

Check all of your electrical connections. It could be intermittent within the pump itself but unless you are familiar with electricity; do not attempt to repair it yourself. There are certain ways that pumps are assembled and sealed properly.
12/31/2023 5:25:49 AM • Flotec 2115... • Answered on Dec 31, 2023
0helpful
2answers

I have had several of

Steaming water as in hot steaming or temperature differential steaming?
12/29/2023 3:14:31 AM • Flotec Automatic... • Answered on Dec 29, 2023
0helpful
1answer

My pump would only come on for four sec. than go

How old is the pump? Short possibly in the windings of the motor? Just spit balling here.
12/24/2023 6:08:10 PM • Flotec 3.4 Hp... • Answered on Dec 24, 2023
0helpful
1answer

The switch has failed on

Did you note to where the 5 wires were attached to the old switch? Does the switch resemble the other less a terminal? No instructions with the new switch?
12/24/2023 6:06:14 PM • Flotec 1/3... • Answered on Dec 24, 2023
0helpful
1answer

Replace the shaft seal on a flo-tec at251001 pool pump

It's pretty straight forward. Be certain to take pics so that you are certain about the shaft seal location and use waterproof grease for re assembly and try not to run it dry.
12/24/2023 6:04:09 PM • Flotec Pool &... • Answered on Dec 24, 2023
0helpful
1answer

Pressure fluctuates

There must be a hairline crack to where it is only noticeable when the pump starts to run creating a vacuum.
12/24/2023 5:58:01 PM • Flotec 1 - 1/2... • Answered on Dec 24, 2023
0helpful
1answer

Flotec E100ELT 7 yrs. Running continuously. Unplugged. High water alarm on bu no high water. Off x 2d. Pump into new outlet running continuously. Plugged alarm and smoking. New switch?

I would say to replace the switch but if you know how to meter it; that would definitely tell you. Also check for obstructions.
12/24/2023 5:56:07 PM • Flotec Garden • Answered on Dec 24, 2023
0helpful
1answer
0helpful
1answer

I have a Flotec model fp5172. Will this pump automatically shut off when it reaches max pressure?I

No, this pump does not natively turn on and shut off based on pressure. You need to add a pressure switch and tank. Flotec has the manual for the FP5172 here: https://www.pumpagents.com/pdf/FlotecPumps/Flotec-FP5172.pdf . I hope this helps. Cindy Wells
9/7/2023 12:48:47 AM • Flotec Plumbing • Answered on Sep 07, 2023
0helpful
2answers

Why is my submersible well pump kicking on with good pressure for about 1 minute then just stops for about 3 min and kicks back on back and forth.

Might be a bad float switch, bad relay kicking out, or possibly the motor tripping it's thermal protection if it's getting hot.
3/16/2023 12:05:07 AM • Flotec 1 Hp Deep... • Answered on Mar 16, 2023
0helpful
2answers

How to clean a sink flotec pump

It sounds like the float is stuck. Try pulling the wires coming out of the tank(shake them a little) and see if that will free the float and shut the pump off
Kurt
11/18/2022 1:31:07 AM • Flotec 1/4... • Answered on Nov 18, 2022
0helpful
3answers

Flotec 42 gallon water tank - short cycling and

These holding tanks are pre charged with air which in turn pressurizes the water. The tank has a bladder and an air valve on top. The pre charge ,over time, loses pressure, and the tank has to be pressurized again.
  • The well pump needs to be turned off.
  • The water has to be drained from the tank
  • Air is put into the tank from the air valve on top of the tank, and is measured with a tire air gauge.
  • The pre charge pressure is set to two psi below the pump cut in pressure.
  • In other words if your pump kicks on at 30 psi, the pre charge pressure is set at 28 psi. If the pump kicks in at 20 psi, the pre charge is set at 18psi, etc.
  • After you pressurize the tank, turn water back on.
  • If water comes out of air valve on top of tank, then the bladder is ruptured and you need a new tank.
  • Hope this helps!
8/27/2022 11:47:31 PM • Flotec Corrosion... • Answered on Aug 27, 2022
0helpful
1answer

1hp pump. Why does it start and run 5 seconds then shut off?

Does this unit have a pressure switch? A lot of pressure switches have an adjustable cut-in / cut-out allowing you to change the nominal operating pressure. If it is only running a short time, you could adjust the pressure switch and see if it helps. **With the power off** make small adjustments, don't crank it.
7/21/2021 2:36:34 PM • Flotec Plumbing • Answered on Jul 21, 2021
0helpful
2answers

Flotec Model FP4022-10 has a

You need to purchase a new pump. Attempting to repair this will only cost you time, money, frustration and a new pump in the end.
RJ
7/14/2021 8:04:21 AM • Flotec Corrosion... • Answered on Jul 14, 2021
0helpful
1answer

I cant get my flotec sprinkler pump 5162 to stop leaking between the motor and pump housing i replaced the large o ring

recheck the seal -gasket and housing [crack or warpage]
7/4/2021 12:16:19 AM • Flotec Garden • Answered on Jul 04, 2021
0helpful
2answers

I have an 7yr old 1.5HP Flotec sprinkler pump. it hums but does not start. does it have a starting capacitor that can be replaced.

https://www.pentair.com/en-us/products/residential/water-supply-disposal/water-supply-pumps/pentair-flotec-fp5172-thermoplastic-sprinkler-pump-1-5-hp.html
4/9/2021 5:19:30 AM • Flotec Garden • Answered on Apr 09, 2021
Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Flotec Experts

john h

Level 3 Expert

29497 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

73781 Answers

Brad Brown

Level 3 Expert

19190 Answers

Are you a Flotec Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...