Questions & Answers for: Troy wrong depth Computers & Internet

My rear tine tiller lurches out of control when I use it How do I keep it from lurching forward on new ground or uneven ground? Hi it sounds like you are trying too till the soil with the tiller in ...

I bought my troybilt rear tine used. When I use it to till new ground (sod) it cuts fine for a few feet, then without warning, it gets on top of the ground, and I can't do anything to make it cut. The

...YOU SO HARD YOU CAN NOT HOLD IT, WHAT AM I DOING WRONG? THANKS DONNA You are trying to dig too deep, too fast. Set the tines at a shallower depth and make multiple passes, gradually getting

PTO making noise when engaged in forward drive I am using my dad's tiller - horse model, ser 646564 and it started making a noise in PTO forward only while I was tilling my flower bed. Depth setting ...

my tiller does not seem to be cutting deep enough i have made dozens of passes on the same section of ground and have barely made a dent. Hi there kimberly, Here's what you need to do. Make sure the ...

troy bult junior has new tines , runs to fast... Troy bult junior has new tines runs to fast MAKE TWO PASSES SET THE DEPTH GUIDE SO IT JUST BREAKS THE GROUND, DON'T TRY TO DO IT ALL AT ONCE. SOON AS ...

Cub Cadet cc4125 - Worn out, excessive smoke with Cub Cadet cc4125 - Worn out, excessive smoke with little use. Excessive 1/8"+ Compression ring end gap. Worn oil control ring (no expansion in ...

my pony wants to just take off just pulls across the garden no matter where i set the depth handle what do i do so my tiller will just dig the garden Your garden seems to be especially hard. Set the ...

I have a 5 hp troybilt pony tiller. The axle seals need replacing can you describe the best way to replace them. This tiller was built in Feb. of 1990. ...

muffler housing What size bolts(screws) holds the muffler & the housing on.The ones on my tiller have come loose & lost..rattles like crazy when it's running usually 1/4 inch x 20x 3/4