Questions & Answers for: Jandy switch pcb Computers & Internet

...Since we converted the unit we were working on it has been trouble-free. John Never mind, I switched the supply voltage to 115, flipped the conversion plug & changed the igniter. It fired ...

...#39;t get them off....tried breaker switch hoping to restart ....but nothing....pool cleaner and fountain are running need new PCB board you might try a jandy surge protector then they will warranty ...

What is the cause of the shut down after 30 seconds when in TSAT mode using the RS6? check your dip switches on the inside panel of the aqualink if you still cannot get it to work i would use the pool

...my blower the relays would chatter and would not turn on. The lights on the panels work thought. I switched the to another aux and it worked. yes the G is just a newer board go to set up and ...

...switch is turned to on. see if you have 24 volts to the brown and yellow wires on the gas valve if wires are loose it wont work either if no voltage to gas valve bad pcb board if voltage to the gas ...

switch to pins 1 and 2 of long plug along top of PCB board make sure to read inside schematic for dip switch positions firemans switch to control heater on and off you will have to turn heater all the