Questions & Answers for: Indesit switch pcb Computers & Internet

Question about W 123 Front Load Washer

1 Answer

...top lid and check the PCB and see if the switch hasn't collapsed causing it to be on all the time. Also if you hold in the go button for about 5 seconds this resets the program try this. Thanks ...

Ad

Question about W 123 Front Load Washer

1 Answer

...IDEAS?? I HAVE TO TAKE THE PLUG OUT FROM THE MAINS TO STOP THE WATER sounds like a faulty water valve if not pcb or pressure switch sorry cannot be more precise but thats indesit for you regards ...

Ad

Question about W 123 Front Load Washer

1 Answer

...switch starts rotating and the light flashes, stops for 2-3 sec than starts flashing again I had the same problem. I followed the signal lamp code and replaced NTC dryer sensor. The same error code ...

Question about W 123 Front Load Washer

2 Answers

...alsobut the heater works, hence I guess heater relay also works. Pressure switch also works. Module connections ok & no signs of damage. Does this mean I need to replace the pcb?urs hopefully ...

Question about WA 125 Front Load Washer

1 Answer

power button on machine shortting out lights flashing have to continuously push power button to get a good connection to do a load of washing machine still in warranty needs switch or pcb

Question about WA 125 Front Load Washer

1 Answer

...flash in cycles of seven times. This error code usually means, ?heater relay stuck?. The heater is switched on via a relay built into the main PCB. This relay is known to get jammed causing error ...

Question about W 123 Front Load Washer

1 Answer

The dial stops on 2 will not spin or empty when switched manually it move round like a second clock through the programes. I have had the pcb. board checked by post with Q E R and they say its ...

Question about W 123 Front Load Washer

1 Answer

...then slow down. when it does switch machine off then select program and switch on and it should be ok.if not it could well be a main fault on pcb .indesit boards are not very good .hope this

Question about W 123 Front Load Washer

1 Answer

washing machine trip switch on fuse box clicks off when using washing machine Main board power circuit fault.disconnect main PCB and reconnect power cable .you can identify the fault. Replace main pcb

...ok, but I click to start button, nothing happens. what can I do for that, please? Thanks suggest calling a local repair service.could be as simple as the door /lid switch or much worse the PCB or ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...