Questions & Answers for: Canon switch pcb Computers & Internet

...dc controller pcb IP BOARD ERROR. PRESS * 2 8 * GOTO FUNCTION CLEAR THE ERROR. SWITCH OFF THE MACHINE WAIT FOR 30 SECONDS AND TURN IT ON. IF THE PROBLEM CONTINUES THE BOARD TO BE REPAIRED OR ...

PCB 2) Turn off the power switch, and disconnect J6019 from J2209 on the DC controller PCB. Measure the resistance between a and b of the following table in reference to the detail code; is it 1 K&

...PCB 1) Turn offf and then on the power switch. Is the problem corrected? YES: End. NO: Replace the Main controller PCB. Control panel PCB 2) Try replacing the control panel PCB. Is the problem ...

SWITCH THE COPIER IR 2800 .IT SHOW;S ME ERROR E000220-0001 HOW DO I CLEAR THIS ERROR E220 0001 A fault is detected on the inverter PCB for the scanning lamp. Main cause The inverter PCB is faulty. The

switch is open. Replace the fixing film unit. 4. Main power supply PCB, DC controller PCB. Press the Start key. Is the drive voltage of the heater supplied by the connector J8 of the main power supply

PCB is faulty. The door switch is faulty. E002 0000 The temperature of the fixing film is as follows: 1. has exceeded 100°C, but does not reach 115°C within 1 sec thereafter. 2. has exceeded

...for canon 6035 Replace Main On/Off Switch of ur machine...Check the DC Controller PCB (In The Back Side Of Machine)Connector on DC PCB J712.check Is Proper connectedor replace DC Controller

...PCB The fixing heater fails to turn on. Thermal switch (TSW1 Turn off the power switch, and remove the fixing assembly. Set the meter range to "Wx1." Does the meter index swing when the probes are ...

...switch it on. pls help me solve this problem. Thanks. that is E000355 When turning ON the power, inconsistency among the serial No. PCB, the controller PCB (SRAM), and the counter memory PCB is ...

...switch is open. Replace the fixing film unit. 4. Main power supply PCB, DC controller PCB Press the Start key. Is the drive voltage of the heater supplied by the connector J8 of the main power supply ...