Questions & Answers for: AEG switch pcb Computers & Internet

Question about 24 in. Favorit 50730W Free-standing Dishwasher

2 Answers

switch on, before even selecting a programme, the solenoid to operate the powder dispenser door operates, then stays activated until I remove power. I've taken the door liner off and the PCB looks OK

Ad

Question about Lavamat 72640 Front Load Washer

1 Answer

...PCB (J6-2 connector): after 2 - 4 seconds, this closes the switch (5-4) which powers the electrical components of the appliance (only if the door is closed). The door interlock prevents aperture of ...

Ad

Question about Lavamat 72640 Front Load Washer

1 Answer

...PCB, before sending the door aperture signals, checks for the following conditions: ? The drum must be stationary (no signal from the tachymetric generator) ? The water level must not be higher than ...

Question about Lavamat 72640 Front Load Washer

1 Answer

...switch it on again I discovered that the washing machine causes a shortcircuit in the whole electrical system in the house only by plugging it in, even when turned off. Hi from retired Englishman in ...

Question about Lavamat 72640 Front Load Washer

1 Answer

... softener system clogged, pressure switch or pressure switch hose obstructed or leaking, wiring from pressure switch to printed circuit board (PCB), wiring from inlet valve to PCB and finally PCB. ...

Question about 24 in. Favorit 60870M Free-standing Dishwasher

1 Answer

... softener system clogged, pressure switch or pressure switch hose obstructed or leaking, wiring from pressure switch to printed circuit board (PCB), wiring from inlet valve to PCB and finally PCB. ...

Question about 24 in. Favorit 60870M Free-standing Dishwasher

1 Answer

... softener system clogged, pressure switch or pressure switch hose obstructed or leaking, wiring from pressure switch to printed circuit board (PCB), wiring from inlet valve to PCB and finally PCB. ...

...switch off and then display the sequence of flashes indicating the alarm. The alarm sequence is displayed for the time in which the buttons are hold down. During the time the alarm is displayed, the ...

switch light just flash and it won't start . Any ideas which part I need to buy as it was £400 and would like to repair it if possible . It has 2 pcb . Could be a short circuit in the control board to

Question about 24 in. Favorit 60870M Free-standing Dishwasher

2 Answers

...switch on, there are no lights on the display. I think its the PCB, are these cheap? Cheers Did you check the emergency shut off switch? Almost all under the counter dishwashers have a wall switch to ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...