Questions & Answers for: Tecnik switch pcb Home

...and a new Technika Oven was installed. The problem that we now have is that the ignition starter switch to light the Gas Burners and Oven has stopped working. We have to manually light them with a ...

switch off when temperature reached. Also the fan in the bottom fan oven works OK as well. User manual shows a schematic which seems to match my oven (when i took the top off) Assume fault is with the

...the washer worked fine. The water is conected to it and all lights come on when I press the main switch on. When I open and then close the door and then press the ON switch, at top left of the

my cloths washer wont drain or spin. Its a Kenmore Heavy Duty 60 series. May be the lid switch. Canyou hear the switch click when you close the lid? It will be just before the lid is all the way down.

...called ERC or clock). For draining problem: Verify drainpump operation - verify that the pressure switch hose is in good condition andproperly connected to tub and pressure switch. Please check ...

...if not check power - step down supply, the pads are responding- if not faulty pads- or the door switches, if the switch contact are not good then it will not trigger the processor to switch on

...remotely what is wrong with your washer. It could be internal wiring/plugs sockets, control panel switches, control PCB, water inlet control valves, door solenoid, main motor, drain motor etc.. I ...

...pumps the water out and the pump will still run There is a leakage in the dishwasher and the flood switch triggers during wash. This causes the pump to operate and continue to run as the flood

the dishwasher switches on and drains the water out while the door is open coul you please help There is usually and interlock switch for the door latch that shuts down the dishwasher if the door is ...

Tecnik Washing Machine 9290 Red light not gone out so not able to open door. I switched it off by mistake but put it on and did the whole cycle again but still on and unable to open door . Please help