Questions & Answers for: Alpine single pole switch Computers & Internet

Subwoofers pop then immediately produce no sound I have an alpine type r 4 ohm (dual voice coils) and a kenwood kfc-w3011. I also have an alpine mrd 500 mono amp. When I turn up the volume past a ...

...Single Pole, Single Throw) toggle switch inline with the turn-on wire. The switch should be mounted so it is accessible by the driver, and whenever you turn on the radio, turn on the toggle switch. ...

...single parking break wire. is there something else that needs to be connected., thanks if you respond. In order for the video to work you need to hook up both the parking and the foot brake leads so ...

...single blue/white stripe, any idears ? No i do not have a wiring diagram for this exact Speaker but this speaker is self powered yes? This blue and white lead is your remote turn on lead, this allows ...

whats the best box for single alpine type r sub get your manual out go to a box calculating site and youll have your answer http://www.carstereo.com/help/Articles.cfm?id=5 go here with your sub specs

...500W or greater, then you'll need two amps to get their full potential. When you connect two to a single 500W amp, each speaker only gets a max of 250W. Also, check the ohm rating for the outputs

Where can you buy the decorative rim trim...or can you buy that seperate? http://www.alpine-usa.com/support/parts

what amp for swr 1021d i dont understand 2+2 ohms or 4 ohms, so what kind of amp do i buy to run a single swr 1021d in my 330ci if it is a dual voiccoil its 2 ohms per coil if its a single voice coil ...

...single pole means on & of for 1 wire In this case the Positive lead will get the switch. You will just have to cut the positive wires near where the switch is needed and connect each end to the ...

radio will not hold sirius signal have to keep getting it refreshed does it hold any memory, ( i.e BASS / TREBLE settings etc...?) if not, pull the head unit out & swop the RED & YELLOW wires ...