Questions & Answers for: Braun shaver socket Computers & Internet

Question about Syncro 7526 Electric Shaver

1 Answer

SHAVER a. gently remove the plastic cover around the electrical socket underneath, using a small flathead screwdriver to pry it open b. the two metallic sides of the shaver can be pulled away starting

Ad

...shaver. Remove the plastic cover on the bottom that covers the corded socket. Be careful, there are a total of two tabs on the short sides and four very small tabs on the long sides. I usedmy ...

Ad

Question about Syncro 7526 Electric Shaver

1 Answer

shaver 5790 doesn't take a charge Plug directly from socket still no luck. Is there a battery I should know about, if so where is it located? Hi. As far as the Service Docs tell me, your shaver should

Question about Syncro 7526 Electric Shaver

3 Answers

...shaver. Remove the plastic cover on the bottom that covers the corded socket. Be careful, there are a total of two tabs on the short sides and four very small tabs on the long sides. I usedmy ...

Question about 360° Complete 8985 Electric Shaver

1 Answer

...Replacement is not very difficult (not soldering involved). You pull off the bottom plug socket, take off the sides, unscrew 4 torx screws on the body, and the shaver comes apart. Good

Question about Flex Integral 5416 Electric Shaver

2 Answers

...socket in base of shaver. Remove screws with #1 driver. The front cover can now slide slightly down while being lifted out of the shaver frame. The PCB is connected by sliding connectors so it can be ...

Question about Syncro 7526 Electric Shaver

1 Answer

...shaver has been loose for months. I could get the charge light to light up by twisting the cord around to the back of the razor in a particular way, apparently enabling the cord and socket to make ...

Question about Series 7 790cc Pulsonic Electronic Shaver

1 Answer

...shaver. Bought April 2011. Cannot get charged. When razor placed in holder. and ON pressed cleaning cycle starts but after short time RED light goes on and fluid enters socket in holder. Razor works ...

...the cleaning unit/charger just the cord factory charger that plugs straight to the 240V wall socket and connects into the end of the shaver. Push the G F I button on your wall plug. It may need ...

Question about Syncro 7526 Electric Shaver

1 Answer

...shaver cord After plugging the charger in the socket, I have to press the sides of the charger, for the shaver to start charging. I have to keep pressing the sides every time the charger stops ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...