Questions & Answers for: roll 2 is empty Vacuums

...2 very furry cats, but it still doesn't turn back on when I clean the cartridge. I had same problem. Turned out to be the filter that sits above the waste cannister. Remove the waste cannister. There ...

...roll is clogged. Pull the hose off and see if you have suction at the end of the hose, that will tell you which way to look for a clog. 1 ) That unit cannot shut off the airflow to hose while unit is ...

2 in a pack). The 2nd belt worked fine for awhile, then broke. I bought more belts, same exact thing would happen. First belt breaks almost immediately, 2nd will work a little longer. Tonight, however

...2 belts, one for the pump and a cogged belt for the brush roll. Take off the belt cover on the left side and you can see the flat pump belt, if it looks ok, then turn unit over, remove the red arm ...

...2 minutes later it's clogged again in the same area! The canister is not full when it clogs, I clean it out every time I use it and it clogs right off. Is there anything I can do to keep that from ...

...2-3 years old. While I was using it today the motor shut off (the light went out but the brush was still on). I examined it and noticed that there was nothing in the canister. Instead, the space ...

...2. Remove dust container from filter assembly and cyclone separator. 3. Hold the dust container over trash can and tap out debris. 4. Check cyclone separator for additional debris, empty into trash ...

...2. While holding dirt cup, grasp filter frame and lift out filter. Empty dirt cup after every use. Dirt cup can be cleaned with a damp cloth. Allow to dry thoroughly. 3. Pull middle section of filter ...

...empty and the brush rolls. Instead of suction it blows. All questions need full make and model https://www.google.com/search?q=sonic+clean+vacuum They make a few models in upright and floor compacts. ...