Questions & Answers for: Sharp roll 2 is empty Computers & Internet

...2. Fold the leading edge of the paper roll 3 to 5 cm. (Do not fold it slantwise.) 3. Insert the paper roll from the left side of the paper holder and make sure the paper roll is set in the proper ...

...2 screws in order to separate the cartridge by lifting and pulling slightly.The top half has two pins petruding from it on the rear and there are no screws on the rear.Dump/vacume or blow out all old ...

...2. Install the paper roll and feed it until it comes out of the front of the printing mechanism. 3. Put a small brush (Like tooth brush) lightly to the printing wheel and clean it by pressing from ...

roll into the compartment making sure it is inserted onto the right hub. 2. Pass the leading edge of the paper through the paper cutter guide and the cutter. 3. Remove any slack in the paper. 4. Close

roll for the SHARP - EL 1197PIII calculator? Your calculater takes 2 1/4 inch wide standard rolls of paper. These rolls are available all over the place so you should have no trouble finding the rolls

roll into the opening. (Fig. 1) 2) Turn the power on and feed the paper by pressing . (Fig. 2) 3) Lift the attached metal paper holder up and insert the paper roll to the paper holder. (Fig. 3) DO NOT

Fig. 1) 2) Turn the power on and feed the paper by pressing . (Fig. 2) 3) Insert the paper roll to the paper holder. (Fig. 3) DO NOT PULL PAPER BACKWARDS AS THIS MAY CAUSE DAMAGE TO PRINTING MECHANISM

...2  Cut the end of the replacement paper roll for a fresh edge and to ensure a smooth feed. Do not tear the paper roll, as feeding a torn paper roll can cause a paper jam. 3  Insert the cut ...

...roll Turn off the Sharp EL-1801V. 2 Cut the end of the replacement paper roll for a fresh edge and to ensure a smooth feed. Do not tear the paper roll, as feeding a torn paper roll can cause a paper ...

...roll with a new one if necessary, and ensure that it is loaded correctly. Reset the cash register: Press and hold the "RC/ON" key for five seconds to reset the register. This will clear any error ...