Questions & Answers for: Dodge reprogram pin Computers & Internet

Question about 2000 Caravan

1 Answer

...pin 1 tells the system you are ready to reprogram it. 4) Close all of your doors. 5) Turn the key to ACC then back off. The power door locks will lock/unlock. This is the signal that the system is ...

Ad

Question about 2000 Neon

1 Answer

...pin that holds the ignition in on mine because i lost my keys which is located on the bottom side. Removing the ignition should be turning the key as you pull it from its holder. Now if you got a ...

Ad

Question about 2000 Durango

1 Answer

...pin 1 tells the system you are ready to reprogram it. 4) Close all of your doors. 5) Turn the key to ACC then back off. The power door locks will lock/unlock. This is the signal that the system is ...

the pin down to lock or pull up to unlock. theres a tech bullitin on that make where computer needs reprograming for the door locks, but it also sounds like you may have a bad actuator lock thats bad,

...scan tool. In addition, the CTM software is Flash compatible, which means it can be reprogrammed using Flash reprogramming procedures. However, if any of the CTM hardware components ...

...pin 1 tells the system you are ready to reprogram it. 4) Close all of your doors. 5) Turn the key to ACC then back off. The power door locks will lock/unlock. This is the signal that the system is ...

Question about 1997 Ram 1500 Club Cab

2 Answers

REPLACED THE MOTOR IN A 97 RAM WITH A 5.2L, AND ALSO REPLACED THE FLYWHEEL, CRANK SENSOR, AS WELL AS ALL THE SENSORS. IT WILL START, BUT MISSES TERRIBLY AND POPS LIKE CRAZY. THE SCANNER SHOWS THAT IT ...

Question about 2006 Charger

1 Answer

Reprogram 2009 Dodge Charger Key Fob George.... What year/make/model does your programing solution apply to? It certainly does NOT apply to the 2009 Charger in this post. There is no circuit on pin 1 ...

...reprogram this computer? the number on the pcm has to match and you will need to swap the eprom out from the old one to the new one. open the unit and you will see a rectangular eprom simply lift it ...

...not be missing they may be left out in engineering, as far as the trans not shifting, was the pcm reprogramed because if you just installed out of a box it unlikly that it will ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...