Question about 4-Cycle Tiller/Cultivator with Border Edger and Kickstand #7262-00-02
won't start. have replaced plug and cleaned filter. any suggestions? check and see if your coil is grounded,if not clean flywheel magnet and check for spark if no spark replace coil,
Tiller will not start replaced spark plug and replaced fuel MAKE SURE YOU HAVE SPARK. ENGINE COMPRESSION NEEDS TO BE MIN 90LBS
Question about Gas Mini Tiller/Cultivator, 2 - Cycle
Mantis tiller 2 cycle will not accelerate. idles fine accelerate it stalls. Already replaced fuel filter, cleaned air filter, replaced gas, replaced spark plug. Only has about 20 hours on it. I would ...
Tiller dies when trying to run at mid to full throttle. I have put fresh 50:1 gas in it, replaced air filter, replace spark plug, and replace fuel filter. It idles just fine. It ran fine the last ...
How do I replace a filter . When I till for a short time the engine dies? air filter- unscrew carb cover the thin greyish cardboard looking item covering the carb opening is filter buy replacement and
Question about Gas Mini Tiller/Cultivator, 2 - Cycle
broken tines on a Model 5222 Mantis dethacher -are they replacement items?TIA YES sure - just locate a dealer and get them from them. They might even replace them free on the labor. Thanks Gary @ Fix ...
Won't start. I have followed all of the directions in the manual and still can't get it to start. I replaced the spark plug. Still doesn't work. Any suggestions? Empty the fuel tank. Add fresh ...
Question about 26-Inch Seer Mens Mountain Bike
...too take your stem into a bike shop and have them hunt around and see if they have an appropriate replacement. The stem bolts come in several different lengths and you need to have the correct one. ...
...starts and runs but lacks power and is slow to rev up Check the air filter and ensure it is clean, replace if necessary.Foam filters can be washed in hot water and detergent, paper filters need to
starter cord replace pull cord remove top starter assy. cut grip from old rope ease rope into spool, when slack remove center screw and carefully pull out spool, tie knot in rope and thread into spool
Usually answered in minutes!
350 Questions
260 Questions
250 Questions
168 Questions
217 Questions