split the electrical connector and remove the nuts holding the motor on. You will see that the collar that had the nut accessed from above will be stiff to move on the wiper shaft. Work it off, scotch
...remove the fluid. If yours don't, you will want to buy a gasket before you change the fluid as you will need to take the pan off to change the fluid. You will probably want to change the filter while ...
...remove water and food deposits. Scrub the screen lightly to help clean it. Check all openings in the deck area for any food plugging--vacuum them out with a wet/dry vacuum. Reassemble all parts in ...
...screen. However you'll need to purchase the proper cleaner. Radio Shack has a product called "Deox it; catalog # 64-4338. This product sells for around $15 (included is a gold contact cleaner). It is ...
...remove them; they just fall apart or you can see the split neoprene. 2. Inspect your accessory belts and the serpentine tensioner pulley prior to beginning the work. Order the belts (If you have over ...
...Remove and clean, and reassemble. If the bottle itself has a crack or split, I've had success using a large 40W soldering iron with a flat tip to to CAREFULLY heat the plastic (often something ...
...remove the flow meter sensor and the TPS sensor then the engine idle. . . . . Query: Have you checked the crankshaft and/or camshaft position sensors? Discussion: Late model vehicles are highly ...
Question about 2000 S-Type
...than a split tank. The pump justs twists out of the grommet - its tight but not impossible to remove and replace if the pump has a fault on its body or pipe cionnections. Hope this helps. good
Question about 1995 Grand Cherokee
...split second and cut back off all the fuel in the EFI parts will be gummed up. the injectors have 10 micron size screens inside. they will be clogged. we start at the tank and work forward, cleaning ...
Usually answered in minutes!
4,236 Questions
3,747 Questions
3,350 Questions
3,279 Questions
3,218 Questions
