Question about StorageWorks MSA20 (0808736947138) Hard Drive Array
...the hp management page the is no point where i can choose the array configuration utility. do you have a tip how i can configure the raid without booting the server? Sounds like you're fixed.
...Raid 5 you should have a utility that will rebuild the damaged drive? Have you tried running this utility? If it fails then you could have a damaged drive in your array and will need to replace it. ...
you are running a Intel processor, please go to the Intel site and use their free scan for Intel drivers utility. Install an updated RAID controller and then try to sort out the issue using Device Mgr
Question about ProLiant DL160 G5 (445198-001) Server
...RAID with 4 discks but i can not enter in SAS Configuration Utility. I press F8 to enter, then i have option for Invoking SAS configuration Utility. Then, it says, PLEASE WAIT, Invoking Configuration ...
Question about ProLiant DL160 G5 (445198-001) Server
utility) and configuring SATA RAID in the advanced section. This doesn't work for all versions - if it doesn't help, please be more specific about your configuration, i.e. what "G" level is the server
Question about ProLiant DL160 G5 (445198-001) Server
...repair diagnastic tools to repair software how to run microsoft repair diagnastic tools scaci and raid controllers Hello, pndwaruh 1.Click my Computer/Computer, right click Main Drive C:, select ...
...utility) create a raid 0 with this drive after the hard drive is being formatted and is configured as raid 0 (no redundant) restart the server and the hard drive should be detected as a new logical ...
...RAID functionality in the BIOS Setup Utility: 1.Boot the server, and then press F10 to enter the ROM-Based Setup Utility (RBSU). 2.Go to the advanced tab. 3.Enter the IDE configuration or hard disk ...
RAID Utility in the first instance (IDE-to-SATA) but not the second (SATA-direct). During all this, the Primary Drive is an IDE ATA 40gb drive, which works fine. I've also disconnected the IDE primary
...utility will allow them to be added to the RAID array. I've tried all kind of different combinations (different ports, numbers of drives, etc), and these same 5 always show up as "WRG ...
Usually answered in minutes!
5,067 Questions
2,066 Questions
1,757 Questions
1,195 Questions
1,096 Questions
