Question about DSR1021 (DSR1021AM) 8-port KVM Switch
...be on the same subnet for this test. Then try to ping it... (command line of your laptop) ping IP-Address -t see if the ping drops, should it drop the nic has issues and an RMA should be needed. ...
how t oconfigure and remove existing ip address of DSR 2010 Connect to the Setup port via Hyperterminal Network settings and config You would need a NullModem cable. Hope that helped.
Question about DSR4030 KVM over IP Switch KVM switch PS2 CAT5 16 ports 1 local user 4 IP users (DSR4030G01)
Avocent DSR4030 KVM over IP Switch KVM. I tried all ports with the same computer, monitor, cables, keyboard and mouse. Firmware updated I have 2 problems: 1) Port doesn't work. It is like that the ...
Question about DSR8020 KVM over IP Switch KVM switch PS2 CAT5 16 ports 1 local user 8 IP users (DSR8020G01)
Mouse cursor is reponding too much slo Check your Mouse acceleration on your target, make sure that the Mouse acceleration is turned off. Do you see this only on the Web interface or also on the local
...if you have TCP port 443 open with stands for HTTPS, which is the login page for your KVM over IP. Thanks and I hope that
Question about DSR8035 KVM over IP Switch KVM Switch
how do you connect to a terminal with avocent dsr8035 using avocent connectors and 9600 baud rate with putty. Hi there, You should have a DB9 to RJ45 converter in the box. This converter is used to ...
Question about DSR8035 KVM over IP Switch KVM Switch
how to you connect to the serial port to a DSR2010? just trying to get a console log i have the settings 9600, 8, 1, n. the 2010 is a legacy KVM DSR, and you might not have the same features that are ...
Question about DSR8035 KVM over IP Switch KVM Switch
...on the model you may be able to do a hard reset. On other models you can access the KVM via IP to determine if there is an issue with the
Usually answered in minutes!
7 Questions
8 Questions
4 Questions
5 Questions
3 Questions
