Questions & Answers for: True humidity setting

...setting on the thermostat, I placed a wireless thermometer in the unit. The thermometer also reads the humidity and currently it fluctuates between 85%-95% humidity. This is much higher than I ...

true 2 door reach in freezer The temp on my freezer is about 5 above, should be no more than 0 degrees which is the highest for the green area. what could be the problem If its getting warmer or more ...

i have a 2 door reach in true freezer which is now just keeping a steady 5 degrees about temp, should be 0 -10, fans, compressor, fans evap are all runing okay, the coils were clean, so what could the

Setting are set on 9 and my drinks are still exploding. Possible that the thermostat control is not reacting to the setting. so you must check if there is any break or replace the unit.

you describe there may be several areas that allow warm air to enter and cold air to escape. If the humidity goes up in your location and the door is open a lot it can cause havoc with consistency

location of temperature setting site inside on the right side of the fan/coil housing. should be a black knob marked 1 - 9 the higher you set it the colder it will run. Normally set on 7 or right ...

...valve to check pressure on low side -5 suction side of compressor , inside temp 74 , room temp 70 , humidity 30% If your running 134 a your short of gas if your running 404a your short of gas check ...

What is the standard setting defrost timer control of ts-49f our freezer is set to defrost every 8 hours for 15 min. this seem to do the trick. we have a true t-49f reach in freezer. try this setting ...

I use my True single door cooler for flowers. How do you adjust the fan so I maintain a 90-95% humidity ? Unless this is specifically designed for this application, the only way to control humidity is

Hi I have a true gdm35 the defrost / fan works but the fridge isn’t getting cold it did for about 1 minute and then stopped. Any info would be appreciated probably a bad thermostat or set at the wrong