Questions & Answers for: Jandy flo switch Home

...glow ok. pressure switch continuity ok. no gas flow. Be sure filter not dirty or too old lack of flo can cause tripping of high heat switch check flo switch also always check simple things 1st ...

...flo code indicates the the water pressure switch is open. If you know that you have more than the minimum amount of flow going through the heater, then the problem is a clogged or defective pressure ...

...flo, is telling us that the combustion fan is either not able to blow enough air either due to a blockage, or a fan failure, OR the air switch that detects this feature has failed, OR the rubber ...

...then comes on again for a second or so, then off, then on again for a second or so, this goes on for a couple of minutes then it shoes an error message of air flow switch ( air flo- sw) bad ...

...pool heater replaced pressure switch, still getting a "FL0" error (open switch in safety circuit) FLO is an open circuit error. you have several other safeties other than your pressure ...

Fault Low Flo Pressure I am getting an error code for the Jandy remote "Fault Low REF Pressure check pressure switch and copper tube to it

...Flo Switch on My Air Flo SW is on. I have vacuumed and cleaned the top under the plastic vent and inside the unit. The heater comes on perfectly and heat is coming out, but when the blower kicks on ...

raybak pool heater says flo and will not run dirty filter or pressure switch or loose wires to pressure switch or plugged inlet to pressure switch

...Flo ? for Flow Error? That would for any number of reasons that the Flow Switch is not sensing enough water flow to trip the sensor/pressure switch or actual true water flow switch. Heater will not ...

...FLO SW error, but I have shorted the switch and gotten no answer or further details. If I wait for hours/days or if I get lucky when opening it up and checking parts I will get a HI LIM SW. The ...