apex pf2025 20 inch tv the tv is turned on, then, about 10 min later,it turns itself off, and it stays that way, even if i turn the it off completely or unplug it, until it turns back on by itself. ...
vertical lines only my tv video shows only red/green/blue vertical line across the middle in a tie like way, any suggestions? You need to re-solder the circuit board that contains the STK convergence ...
loses power, not a house electrical problem. outlet is fine. tv shuts off. unplug it wait a few seconds and green light goes on and it connects again. At times it goes off several times, other times ...
convergence issue Having problems with the red convergence. the tv will run fine for up to 1/2 hour but then the red will be misaligned and you cannot re-line them up. sometimes if you hit the side of
digitrex dsc 2100 After 1 hour of registering, and plodding through all the sponsored ads the suggested help site makes you go through EVERY time you login, I was diverted to the digitrex homepage ...
works fine then wont turn on.. then after a few hours it starts working again,its so annoying What is the Model Number?
...Executive Officer / Chairman Alice Hsu, Chief Operating Officer M. Jeannie Vogler, Senior VP of Global Sales & Marketing Mailing Address Apex Digital Inc. 301 Brea Canyon Rd. Walnut, California ...
Will not eject disk. Almost always, your described problem could be caused by: stuck disc; fault in the load/eject mechanism. It it were a stuck disc, the correct fix would be to open the unit and ...
door doesn't open door doesn't open Try to reset the DVD. Unplugged it for 24 hours... If it doesn't work it need service because the internal rotating part need replace.
my flat screen will not turn on possibility it may have blew out? Try changing the input device to something you are sure works. Switch off TV manually, switch off power, remove plug and retry after ...
Usually answered in minutes!
1,678 Questions
1,342 Questions
1,186 Questions
1,095 Questions
889 Questions
