No Drain Knob on my Singer CSP 1 In reading the manual for my CSP 1 there is supposed to be a Drain Knob for easy draining of Water Tank. There is no Drain Knob (unless I am really stupid and blind) ...
Small oven on double oven Kenmore range quit working The small oven in my double oven Kenmore Elite quit working after using it a few months. There weren't any prior problems - just one day it didn't ...
Inspiration 4205 stitch length won't change Stitch length is stuck and will not change. The knob moves but there is not change in the stitch length and it is stuck in size 0 stitches. Could the knob ...
Question about Featherweight 132Q Mechanical Sewing Machine
My Singer 123q Featherweight just jammed on me in the middle of a seam. It was working fine, then all of a sudden, the needle stopped. The manual knob seems locked, and if I force it, I can get it ...
Question about Electronic Steam Press Iron
...to the temp control .Any ideas Matt The cover is held on by two screws underneath the top cover AND double sided stick tape, You have to remove the screws from the handle plastic knob. Also ...
how do you load the thread on the bobbin? Hi, On the back of the machine, by the hand knob, there is a post that moves back and forth, place your bobbin on this, and slide it to the hand knob, unscrew
rust inside of tension dial would like to be able to take tension knob off for a part so that I can clean the rust out inside but I don't know how to take it apart If your tension knob is on top of ...
Question about Electronic Steam Press Iron
Singer 478 stitch lenght control misses a spring? My Singer 478 has inoperative stitch lenght control. The center knob (that is also used for rewerse) of the lenght control should push a pressed lever
Question about Confidence 7469 Mechanical Sewing Machine
my machine will not sew over double seams it just goes up and down in place; also, it does not feed at the beginning of a seam Have you tried adjusting the tension? How about adjusting the height of ...
Question about Confidence 7469 Mechanical Sewing Machine
On a Singer 328k when I turn the knob on the handwheel the needle still goes up and down You haven't disengaged the knob properly. Did you keep the hand wheel from turning with one hand when you ...
Usually answered in minutes!
350 Questions
260 Questions
250 Questions
168 Questions
217 Questions
