...the motor is in good condition with no loss of compression no blowing smoke etc,all new plugs leads dizzy cap rotor button etc,anyone with an idea will be my best friend for life cheers phil Try ...
...backfires and bogs under load the thing has became undrivable, I have just put on a new tbi, coil, dizzy cap and rotor button, I have timed it but still with no joy please can anyone shed some light ...
...cutting out.Changed coil but problem persists. Any advice would be appreciated. Don. electronic dizzy modules do this when they get warm they cut out but can start up again within minutes ! very ...
mabe on the top of the cap is a mark or number if not then there should be a mark on the lip of the dizzy! if not then just choose one near the front & set the points at that point on the point of
...02 sencors on it put some hiflow cats and its stright pipe what is wrong with it? have u reset the dizzy ...
...i give it lots of gas but still runs poor (feels like a bad case of misfire) have swapped rotor and dizzy cap they were bad but still same issue . Please help and Thank you check the fuel filter has ...
Question about 1998 Sierra
...sure about the year here ,Sorry but iam a europeon mechanic whos never seen this car but i dont see dizzy caps on vehicles from about 2000 ...
magnet shavings inside distributor cap pulled my dizzy cap off and found metal shavings inside. my engine also has a hesitation while under load. are these shavings normal? . No they are not . It ...
...must be timed, set engine, to TDC 0-degrees, #1 piston on firing stroke step1 is that. so new dizzy super easy to put back same. time. the ICM runs the coil but the ICM has inputs, that must be ...
Usually answered in minutes!
29 Questions
23 Questions
2 Questions
14 Questions