Questions & Answers for: Seagate cs 80 Computers & Internet

dead controller card on ST380011A I have a dead Seagate Barracuda HDD that needs a controller card. I have already swapped out the controller and it works fine. I was wondering if you might know where

bad sectors removal and formating Seagate 80 GB My seagate 80 gb hard was corrupted and windows not working.I deleted all teh particions and after new particions,windows was not being installed.Soem ...

SEAGATE IDE 80 GIG BARRICUDA DONT HAVE CYLINDERHEADS SECTOR INFO ALOT OF PEOPLE NEED THE**CYLINDER,HEADS,And SECTORS INFORMATION,-For the SEAGATE IDE 80 GIG BARRICUDA INTERNAL HARDRIVE-(7200 RPM Model

I have a ST3750330AS SATA HD and wish to know the jumper settings. Thanks CS (cable select) for primary drive (Default setting anyway) SL (Slave for secondary)

Barracuda 7200.7 ST380011A 80 GB Hard Drive: SMOKE SET ,NEEDS ELECTRICAL DIAGRAM... Smoke set needs electrical diagram How to check barracuda 7200.7 ST380817AS

...is not shown on the label then it will be marked on the circuit board. MA = Master SL = Slave CS = Cable ...

How to transfer data from seagate barracuda 7200.7 ST380011A 80 GB hard drive to another hard drive after crash? You need a usb cable to harddisk. than a computer running linux. connect hd by usb to ...

which is the correct jumper settings on Seagate Barracuda ATA IV 80 GB Hard Drive Hello Please see the image below for correct jumper setting Hope this helps, if so do rate the solution

I have install windows in 80 gb wd, and i need to copy from another 80 gb which is seagate, both are IDE, and I have only one IDE interface in my system (Dell 280) and I am unable to use seagate as ...

Barracuda (ST380215A) 80 GB IDE (ULTRA ATA) 7200.10 Hard Drive Problem While installing Windows Xp sp3 hard drive not detect @ partition screen System configuration is as: Processor:- AMD Athlon XP ...