Questions & Answers for: Marshall buzz feed Computers & Internet

won't do anything but buzz very loud The amp won't do anything but buzz very loud. It has been working until now. The input or the CD input jacks may have a bad solder joint on the circuit board. If ...

Buzzing fan on a Marshall mg 100 head My marshall mg 100 head has a cooling fan that buzzes for about 60 seconds when I turn it on, then the buzz goes away. Can I order a new fan? Try to remove the ...

...buzz like feed back can anyone help Try checking the preamp out which would be located at your line out plug. Plug that into another amp or get a 1/4 inch to RCA splitter and plug it into your home ...

I have a buzzing noise coming from my Marshall AVT100. It is present on all the channels. Is it likely to be caused by the valve? The valve inside is made by Electro Harmonix and it was made in Russia

...upon power up when output module on fan-cooled heat sink is plugged in. Increase the fuse and loud buzz comes out through the speaker. No volume control then. Unplug the module with original fuse

I play Gibson USA Sgs, one with 490/498 humbuckers and one with 57classics....The Amp has a loud buzz like feedback all the time on the overdrive channel. If the amp is quiet with cables unplugged at ...

its a marshal 8080 valvestate 80 v and it buzzes and some of the knobs crackle when turned, Buzzing could be normal for this amp, especially if you have the gain cranked way up (or the volume way up) ...

I have a buzzing noise through my MG50dfx every time I use the foot switch and have changed to the over dive/distorted sound. Any help would be wonderful? Has it always done this? If it's just a mild ...

...you can get these symptoms. If your amp is a solid state Marshall or Fender and there is a random buzzing sound with no guitar signal connected- hit the side of the amp and listen for the buzz to

Had lots of buzzing coming from the back of Marshall AS50D. Removed the back cover and buzz gone. Any problem with leaving back cover off? Warnings on the back say not to remove the cover! It was ...