...1. Press and hold SEL (select) for more than 2 seconds. ?DEMO?, ?CLOCK H?, ?CLOCK M?, ?DIMMER?, or ?AMP GAIN? appears on the display. 2. Set the hour. Select ?CLOCK H? (hour) if not shown on the ...
Question about RX-E100 5-Channel Amplifier
Kenwood stereo control amplifier KC-206 doesn't work Hi. Thanks for looking at my question. I have a KC-206 preamp which won't work. It lights up and the front controls appear to work but the digital ...
...1 Hold on the SEL button 2 These options are changed using a combination of the UP, DOWN, PREVIOUS & NEXT buttons along with the Volume Knob. (This is shown with a picture, I'm just trying to ...
The echo is stuck on full blast & turning the knob doesn't change it on my JVC XL MV303. What can I do? thanks John If the status screen on your TV doesn't indicate any response to the knob I'd ...
Question about AM FM CD DET FACE CAR STEREO
...out,,I would take it and make sure connected good and pos and neg correct,,goodluck The internal amp setting is on low. What you need to do is:* Press and hold the "Sel" button, located next to
how to set time & color on KD-R310 To set the time for this unit, press and hold the menu button. Press the track advance button ">>>" til it reads clock H, then rotate the volume knob to
...knobs .. so take your owntime & finalise the exact position of those knobs..then switch off tv ..fix back the tv cover .. then switch on tv again ....that's all .......100% GUARANTEE again ...
...but then cut off completely and turn back on in 10 minutes later, than repeat the problem. my amp does not go into protection mode, its not even warm, volts are great, grounds are great,ohm
Usually answered in minutes!
9,125 Questions
3,840 Questions
3,158 Questions
2,979 Questions
2,660 Questions
