Questions & Answers for: Sunfire amp knobs Saws

Behringer ep2500 amplifier Can I drive 4 speakers with this amp by splitting the output signal? If so, is it ok for two of those speakers to be 4 Ohms, and the other two to be 8 Ohms? Yes you ...

...and potentiometers to ensure the are connected directly to the ground-lug (green wire) inside the amp. Make sure it is disconnected from the power for a few days before you open it, or the 200volt ...

how do i bi amp sx 1250 to get both channels of each side to work together you are actually not bi-amping the unit, you are bridging the amp. this really only works as long as all channels produce ...

amplification I Just bought a new amp gfa adcom thats rated 5x 150 watts per channel, But my speakers that I plan to use klipsch say 100watts maximum continuous (400watts peaks), Can I use these ...

...plugged into, which I think has caused this whole problem. removed the switch out of the loop but amp still frying ac fuses. what's wrong and can it be fixed by somebody other than the overpriced ...

...HUM on my left channel (front and rear). The signal is from Sunfire TGP5. I have isolated the amp altogether with only speaker connections and still get the HUM. I even powered it through a

Which side is the passive speaker on? If you are looking at the sub from the back (side with the volume knob etc) then the passive speaker is on the right.

my sub makes a crackling sound when i turn up the volume. it does work in passive mode that's just likely a dirty potentiometer. (the circuit under the knob)

...visible break ? If the fuse has gone you would get no power at all. Subwoofers are basiacally mono amps that only put out bass tones. So when you get no sound the likely cause is the semiconductor ...

...remove the volume knob on the Sunfire Subwoofer? Does it pull out easily or do you have to take the amplifier plate off and tighten from the inside? The volume knob is loose. When I push in on the ...