Questions & Answers for: Jenn-Air amp knobs Ovens

Thermostat calibration? How do I calibrate the oven thermostat? It's on page 32 of the manual for Thermador's built in convection ovens. 1. turn off the oven 2.touch and hold the start pad and then ...

locking mechanism for jennair why won't the self-cleaning locking mechanism unlock? The "lock" light is off, it is cool. Is it the temp sensor? I have Jenn Air oven S136-C with a locking bar. After ...

Jenn Aire lock for self clean in locked position I was going to try to self clean my electric single oven @ 18 years old but couldn't figure it out now locking slide bar stuck in lock position Thanks ...

fan control knob sheared off w/ part of stem... can i replace,if so which parts tks, mgw You need to replace both the control knob and the switch it is located on. Please rate my solution. Thanks.

on a certain amount of current. If you have a 120V house system, I think the valve needs 3.3 to 3.6 amps to turn on. The current flows through the igniter and then through the valve, as in a same path

I have an old wall mount convection oven. The model number is illegible. It has knobs for mode and temperature controls at the top left. How do I start the self cleaning. It will lock but will not ...

...cycle and let it run all the way. Set it for the least amount of time that it will let you for example try a 15 minute clean cycle. Once it goes through it and turns off automatically it may ...

Oven is finished cleaning but the door says "locked". The panel just shows the time and "locked" in red, under it. Help I have Jenn Air oven S136-C with a locking bar. After ...

jennair 88370 convection oven from 1979 fan blower is making a loud noise? also took the knobs off and not sure which way is on/off any old diagrams of that? Lastly, the self cleaning isnt working, ...

I have a Jenn Air JJW9830DDP double oven electric, and the temperature in the oven is about 100' less than what it reads on the display. I tested the temp sensor and it ready 1073 ohms. Any s ...