Questions & Answers for: Peavey amp knobs Music

...amp (worked fine) Heres the wierd part.. I can plug into the return jack and it gets almost as loud as it used to. (gain and the eq knobs dont work though.) The preamp section has a problem. It could ...

plugged in my new head and no volume, very faint guitar, but nothing when i hit the post and pre knobs already chek your 5 1/4 plug cable!

I was just playing my guitar, and everything was fine. Then, I sat it down for 5 minutes, and when I came back, all the sudden the "Tone" knob was loose and wiggly. Is there any way to fix ...

amp with the two knobs in the upper right of the panel. Adjust the "time" knob for the delay or effect depth you want. Then go over the same settings in the same order until you get the sound you want

...is a reasonable amount of work to access the jack as usually all the front panel knobs and hardware has to be undone to remove and replace the jack after the amp chassis is removed from the

peavey 4080 amplifier problem with ddt light ddt light stays illuminated all the time when running even at very low volume but the amp does not get warm and sound does not seem to be affected. DDT ...

no distortion on any red channel all settings sound the same(vypyr 30) amp seems stuck on 1 setting and only works properly now and again,effects and st.box working as they should,seems stuck on twn ...

...knobs aren't working at all for both the lead and rhythm channels. The amp works fine other than that. Except every once in a while it seems like the presence/resonance triggers on and then off again ...

...knobs on the amp? If your bass and cable are in working order and there is no noise at all when you turn the volume to 10 or a bunch of popping/static on your way to 10.. I would clean the pots and ...

Do do 115 Peavey amplifier have a fuse that can be blown Yes..these amps due have fuses. Check to make sure the fuse is good, it should be close to the power cord in the back under a small, black, ...