Questions & Answers for: Nitro amp knobs Dishwashers

Amp in Protection Mode i Have a Bmw Nitro 1200 wat amp with 2 plye 1200watt dual voice coil spearker's and i have everything hooked up right, but when i turn my radio up, My amp turn's on to ...

the amp wont come on the amp just stopped working the protection light wont even come on i hooked another amp up to c if it was the wireing and tha new amp came on i checked the fuse and its good ...

what size amp should i get for performance teknique sub-woofers what size amp should i get for performance teknique sub-woofer 1200watts speakers, already have a nitro 643 1200 watt amp, but amp is ...

...amp, and this happened to his. Basically, just start from scratch. Unhook every single wire, and rewire it. If that doesn't work, look at the side of it, and there are a few knobs that you can adjust ...

my nitro bmw-486 amp is in protect mode how can I my nitro bmw-486 amp it just turn in protect mode is there a way that I can fixed protect mode is activated either because of a short in a speaker ...

hello, i have a nitro bmw 486 amp. i use it to power my 2 subwoofers in my trunk. its a very good amp and sure does its job, but randomly the light will turn red, which means protect, and my subs will

nitro 483 amp where do you hook up the power it has a gnd rmt and +12v what hooks up where Fused 12 volt power wire from the battery connects to +12V at the amp. Chassis ground wire connects to gnd at

My amp overheated and entered protect mode and I smelled burnt wiring what do I need to do It is highly likely your amp's output MOSFETs burned up. as a quick test, remove all speaker wires and ...

I have the Nitro BMWX 483 4 channel amp, BMWX 484 2channel amp , and I have the Nitro BMWX 424 4 band EQ !! Now what I'm trying to do is hook up both amps together to the EQ ! So far, I hav the ...

The fuse that is on the amp keep blowin!!! And the bass knob that was ran from the amp 2 the dash board shuts off when the fuse blows allso!!!! But the to blue bar lights inside the amp stays on after