my vibe 286 4000 watt lanzar amp wont stay on.. my amp turns on then off again. all my wires are good and fuses hooked up just like old amp and it worked fine. if it is my remote wire not sending ...
...up, im positive that everything is wired correctly. I set the gains to about 3/4 of the max. the amp plays just fine at low volume but when i turn it up i will only run for a few seconds to a ...
Blowing of fuses Hi, my name is Denver, I have a Lanza Optic 500.2 amp everytime i put the bass louder it blows the fuse, im using a 60Amp fuse, In the owners manual says the amp(500.2) takes four ...
Question about SDBT75N Car DVD Player
how to hook up my rem amp wire to this player it does not have it does not have a amp out put for my subs how do i hook it up then If by saying amp outputs you are refering to the RCA jacks on back of
Question about 2H 1000W MOSFET AMP Car Audio Amplifier
amplifier protect circut is on and wont shut off the amp was working fine and i was about to adjust my gain controls and it just shut off i didnt touch anything it just shut off, i had been cutting in
my cd player does not have an external amp wire but has amp connect jacks how do i hook it up to my amp? You should plug your RCA's from your amp to your radio output. Then you should take the blue ...
...subwoofers. no matter how i wire them or what style box i've tried i get the same results. Its your amp. It may be pickin up noise from your car electrical system. Make sure your amp power wire ...
can a rockford bass knob work on a lanzar amp as long as the connections fit, or you can make the fit appropriately without the poles touching, it will work. All a bass knob is is a potentiometer ( ...
Question about VIBE266 Car Audio Amplifier
So i hooked up the amp useing the pre-existing 8 gauge wire with a 30 amp fuse it worked for about and hour and started blowing the 30 amp line fuse. i replaced the line from 8 to 4 gauge and ...
safe mode light is always on amp willmnot turn on this is because this amp has been overheated and the power supply inside the amp can only go into safe mode. this is whats known as "burned" or ...
Usually answered in minutes!
980 Questions
644 Questions
497 Questions
317 Questions
274 Questions