Questions & Answers for: Dayton amp knobs Radio Communications

torpedo heater lights and runs with control kknob pressed in but shuts down when control knob is released. Change the thermocouple. The thermocouple scenes the heat from the pilot lit and signals the ...

Dayton 3e239e looking for operation manual Need to light pilot light Normally you turn the gas valve to the pilot position, light the pilot, hold down the gas valve knob for 30-40 seconds and release.

...to run my new Dayton Heater (3Vu34A) I was planning to run a new wire from my dryer plug (with a 40 amp breaker), that is not being used, to my garage that I will be heating. Is the 40amp protection ...

Looking for new parts for the wall control (knobs Looking for new parts for the wall control (knobs etc..)) Any decent hardware store should have what you want.

replacement knobs?? where can I find replacement knobs?? its for a dayton baseboard heater model 3ug280?? any suggections contact grainger.com. they can get any Dayton part.

The red power wire leading to the thermostat shows signs of overheat. About onehalf inch of the red coating has melted/browned and then it completely seperated from the clip on the back of the ...

Have a dayton 3F405D propane greenhouse heater don't know where to light the pilot light. Find where the gas line connects to the gas valve on the back of the heater, from the gas valve, follow a ...

...Dayton Heaters are a product of Grianger Industrial Supply. The have locations all across the US & Mexico or you can find them online http://www.grainger.com/Grainger/wwg/start.shtml Hope this ...

furnace If this is a standing pilot system, turn the gas valve to pilot position. push in the knob & hold while lighting pilot...keeping holding knob down for a minute... this will pick & hold

...is owned by WW Graingerhttp://www.grainger.com/Grainger/wwg/search.shtml?searchQuery=1TMY6&op=search&Ntt=1TMY6&N=0&GlobalSearch=true&sst=subsetContact Grainger ...