Questions & Answers for: Yamaha amp knobs

...and I cannot get sound. I looked for a place for a fuse in the back but no fuse obvious. The amp appears to come on without a problem - but blinking light on knob with no sound. Any

...amp communication problems. knobs under the front door (bass, treble, balance) don't work. DSP effects must be on for any sound to work...can't just play in stereo. If I push the "effects" button to ...

the volume knob is flashing red on my AX-SD1 amp..no sound. i do not have the remote control for the amp..the red light started flashing one day as i switched it on..can this be fixed? Unplug the ...

...ends(and not a pull Knob) A good bike shop should(because I do)replace the inner cable cable only & save you some money.If you can have it repaired first ask for a quote on how much it will ...

when turning the volume knob i get static & loud feedback. does it need to be cleaned? Yamaha Model # CR-640 its old, yes. good luck

...amp and fade the volume knobs up. That should give you power - provided your board, cables, amp and speaker are working properly. If you're going to an EQ first, place the cable carrying the signal ...

...using my rxv-1600! Connect your speakers to the Presence Zone 2(3) output on back. Then power up amp and select zone 2 on front of amp. Nothing will happen, because as I found out, you must route ...

...down your mid and treble on the amp itself. Turn all the knobs to middle and turn them one at a time till you get the sound your looking for. The knobs on your instrument and amp control the

i have older yamaha amp rx-v692 turns on but the volume knob has a light on it that is flashing wont play is there a reset ? If you look in the manual on page 37 it explains the Mute button and that ...

...amp on eBay. When it arrived I opened it up and noticed it feels like the volume knob - the biggest dial on the front - may be made of plastic. I find that very unlikely for such a refined, high-end ...