Questions & Answers for: Volfenhag amp knobs

whats is the perfect amp? I was wonder what is the perfect amp for my 2 zx-4712? I have 2 of these 12" running in a Large slot ported box with an: "Ultra Linear UL2402" 600RMS X 2 @ 4Ohm (Stereo) ...

protection light after being installed my amp worked fine, but after a while it shut off and the protection light came on. so i uninstalled the amp. what must i do to get it to working again. and can ...

Volfenhag zx-8400 amp and ZX-4712DVX subs Hey everyone, I'm really stumped here. I was under the influence that the zx-4712dvx subs would work best with a Volfenhag amp. So I went ahead and got a pair

IF THE WOOFERS HAVE 2 VOC.COIL EACH HOW DO YOU CONNECT WITH THE AMP THAT HAS ONE CHANNEL WITH TWO + AND TWO -. it depends on the load you want to present to the amp. un 12, 2009 - If woofers are 2 ...

i have a volfenhag zx-8400 amp. i dont have a manual. whats the proper way of conecting amp? its mounted on my speaker box, which is ported, 12' volfenhag 2500 watts. on the side of amp it had voltage

...knobs on my volfenhag 840 watt amp that's running to 2 10 inch subs, for max performance? Thete is a gain, low pass, high pass, and bass knob, as well as a low pass/full/high pass switch and a ...

where can i find out how many amps the 5004 draws where can i find out how many amps the zx 5004 draws u are going to need at least 40 amps to run this.

i dont know if my amp is blown or not if my amp got fried would of it stinked? it just stopped working..and the protect light turns on when i turn the car on it blink twice then turns off....but when ...

what size wire should i have for two 12 volfenhag subs why my subs keep melting the fuse on my amp I would use 10 to 12 gauge wiring.  As fare as your amp's fuse...Check to make sure you are ...

why does my amp keep cutting off after a few minutes Either amp overheating Speakers wire are dropping below 2 ohms Too small of wire feeding amp Make sure amp has plenty of open space Make sure wire ...