Questions & Answers for: Crossfire amp knobs

Green LED comes on then fades out When I power on my amp the green LED lights up then dims and no sound comes from the speakers. The light will come back on and I will here a faint pop from the ...

...i have my remote wire up the power stay on. It used to turn off with the radio. need help. also amp has a yellow knob inside the amp. any one know what that is for. What kind of amp is it? Your ...

...10" subs and when i turn it up loud it shuts off what could be the problem Your head unit and the amp are turning on at two different times. Go to Radio Shack or an electronic component retailer

do you know anything about the 1400 series crossfire amp is there a certain way to hook these amps up? Unfortunately I can only get the PDF version of the VRA series on these amps. Here is a link to ...

...a new one my radio would start but only the head unit would power up. I went back to check the amp and its not powering on. I believe its the amp but don't know where to purchase the fuse. ...

what does the prt light mean on my crossfire vr2000d amp. the amp is not working and this is the only light on. I just swapped it out with a jl audio slash amp that worked fine and now new amp is not ...

what is the passwoed od thegoodagent These amps have no "password." What seems to be the problem with your amp?

how to wire a crossfire vr602 2 channel amp at 4ohm and 2ohm Trying to hook the amp to 2 jl 10W0v3 4ohm subs but know how to wire amp at 2ohm or 4ohm. Also would it be better to run the subs and amp ...

Wiring a crossfire vr602 at 4ohm Ok,my amp shows it can run 150x2@4ohms,300x2@2ohms and 600x1@4ohms bridged. My question is how do I hook it up to get the 150x2@4 ohms? I know how to bridge it for ...

...amp 50.4 , theres a few knobs not sure what they should be turned to The gain knob is used to control how much the volume (output) of the amp increases with each increase in volume on the deck ...