There are a few products that will remove mineral buildup.
Vinegar - slow but it works. Let it sit overnight if filling a reservoir.
If it's on a surface saturate layers of paper toweling with vinegar and
place on the surface and let it sit overnight. You may need multiple
applications depending on the buildup.
Any 'De-Liming' product (containing Hydrochloric Acid) - Faster, but
can discolor metal surfaces if left on too long. Wear plastic gloves
when working with these products. If filling a reservoir you may want
to dilute it with water (50/50) and leave for an hour. You can make a
stronger dilution and/or use it full strength, but be careful...
De-Liming Acids foam when they hit lime buildup, so be sure to keep the
surrounding area protected or do it in a sink.
Keep in mind it will discolor metal so be careful if putting it in a
stainless steel sink. Always rinse and flush with clear, cold water
immediately after cleaning. Vinegar is the safe way, but takes time and
multiple applications :)
If the iron heats but steams improperly, inspect the soleplate and clean the vents (see below) and flush sediment out of the steam chamber .
If the iron produces too much or too little heat, test the electrical cord . Also test and, if needed, adjust calibration of the thermostat .
If the iron does not spray properly, inspect and clean the nozzle.
If the iron leaks or spits, clean the steam vents, nozzle, and tank.
If the iron sticks to fabric, clean or repair the soleplate. If the iron stains fabric, clean the soleplate, clean the tank with a commercial cleaner, and use distilled or filtered water.
369 views
Usually answered in minutes!
×