My ar 5316 copier is displaying H2 and it is not able to make any copies
H2 means the thermistor is open or defective.
Try to press the copy button when h2 appears you'll see the sub 00. You dont need to replace the whole fuser unit. Try first to cancel the trouble by entering the simulation.
Try to press the # - interrupt- C- interrupt (one after the other.) then enter 14 then copy button. If it doesnt work replace the thermistor.
The last part that you'll replace is the main board but that rare. Mostly the thermistor is defective when that trouble appears. Hope it could help you a lot.
H means heat. You need a new FUSER.
Write your answer... It worked thanks alot.
All I did was to press the
#,interrupt,c,interrupt in sequence. The
display then went off.
I then press the numeric keypad 1,4 and
start botton in sequence. It's fine now.
A big thanks.
SOURCE: Sharp AR 5316
It worked thanks alot.
All I did was to press the #,interrupt,c,interrupt in sequence. The display then went off.
I then press the numeric keypad 1,4 and start botton in sequence.
It's fine now.
A big thanks
Ometan Goodluck
Nigeria
594 views
Usually answered in minutes!
×