How do I redirect the dryer vent from the rear to the left side cutout?
SOURCE: Dryer cuto off
You probably have a bad thermistor located on the blower housing, a small black plastic item.
SOURCE: Banging noise as dryer spins, wore hole in side of dryer
I need to know your make and model number in order to give proper advice. Joe
SOURCE: Kenmore dryer w/back vent, need to make it vent into floor/bottom
you will go to any hardware or home depot and purchase a metal ductwork elbow. that will direct the vent down 90 degrees
SOURCE: How do I disassemble the dryer vent... Problem
Hi For complete disassembly instructions you can download this
service manual for your Maytag MDG9700A Dryer. Hope
this helps...please post back for further assistance. Daniel
SOURCE: Outside of dryer very hot to touch when drying
The motor is on the left side and can start getting very hot due to lint/dust collecting in the motor. Best thing would be to remove the motor and blowing it out with compressed air, and while you're at it it might be a good idea to clean the whole inside of the dryer. Worst case scenario is that the motor is too far gone and may need replacing, but usually a good clean is sufficient.
98 views
Usually answered in minutes!
×