Cant program lost intstructions

here are the steps to program your madcatz mc2 univerasl wheels and pedals set

programming accudrive

simply press the calibrate button
two red leds near tht center will show the deadband setting and two green leds near each end of the display will show the current maximum range setting. to adjust the settings , use the up/down buttons on the d-pad to widen/narrow the deadband and the left/right buttons to widen/narrow the amount of distance needed to move the wheel to achieve maximum turning position

reprogramming the button layouts:

mc2 has been designed to be fully programable for playstation,gamecube,and xbox,only pedals and stick shift can be re-mapped . to remap stick pedals and stick shift :

1.press the program button ( Note in program mode the controller will not function in game )
2. Once the program button has been pressed the program led will light up , you may begin programming
3. press the pedal or stick shift you would like to remap (led begins flashing)and then press the button that has the desired function(led turns off)
for ex: to make the right pedal button function as the b button the following steps would be followed:
1.press the program button the program button will light when activated
2. press the right pedal button the program light will flash
3.press the b button
4.the program light will go out the button has been reprogrammed
to clear the configuration settings and reset it back to default settings press the program button and then press the button twice to reset all programming must be done one at a time . if you wish to change multiple buttons repeat the steps above for which button you want to change .

here is the website :

www.madcatz.com

email : techsupport@madcatz.com

phone # : 1-800-659-2287( united states only)
1-619-683-2815(outside United states)

then can also send out a copy of warranty if requested here are the steps to program your madcatz mc2 univerasl wheels and pedals set programming accudrive simply press the calibrate button two red leds near tht center will show the deadband setting and two green leds near each end of the display will show the current maximum range setting. to adjust the settings , use the up/down buttons on the d-pad to widen/narrow the deadband and the left/right buttons to widen/narrow the amount of distance needed to move the wheel to achieve maximum turning position reprogramming the button layouts: mc2 has been designed to be fully programable for playstation,gamecube,and xbox,only pedals and stick shift can be re-mapped . to remap stick pedals and stick shift : 1.press the program button ( Note in program mode the controller will not function in game ) 2. Once the program button has been pressed the program led will light up , you may begin programming 3. press the pedal or stick shift you would like to remap (led begins flashing)and then press the button that has the desired function(led turns off) for ex: to make the right pedal button function as the b button the following steps would be followed: 1.press the program button the program button will light when activated 2. press the right pedal button the program light will flash 3.press the b button 4.the program light will go out the button has been reprogrammed to clear the configuration settings and reset it back to default settings press the program button and then press the button twice to reset all programming must be done one at a time . if you wish to change multiple buttons repeat the steps above for which button you want to change . here is the website : www.madcatz.com email : techsupport@madcatz.com phone # : 1-800-659-2287( united states only) 1-619-683-2815(outside United states) then can also send out a copy of warranty if requested