Questions & Answers for: throttle pot - Page 6

...more than likely need a new speed pot but some are connected to the throttle pot as well so it could be that which is at fault. Could also be wiring or worst case, control box but this is

...throttle pot shaft. The flat headed 'screw' you can see is not actually a screw but the bottom of the throttle pot shaft. This will only turn about 45 degrees in each direction and is not meant to be ...

...throttle pot Throttle posistion switch? ON what? On most it is located on throttle body on side opposite throttle cable. You may need a scan tool to set it to specs if it is adjustable. DEPENDS ON ...

...hi, you have to expose the throttle pot that attached to the throttle lever , looking at the pot you see three wire connects, swap over the outside ones but leave the middle one alone. Regards

...is dead centre, got a meter ? then disconnected the throttle pot connector and measure one outside pin to centre pin , it should measure around 2.5k ( resistance) Regards Rob ...

...throttle control POT to an amigo value shopper? I see where it goes on the circuit board but need to know the value and the pin out. Thanks in advance. trying to speed up my old value shopper I ...

...throttle pot to the controller ? One last thing , the speed pot,,short the two white wires ? and see if there is a improvement as it very hard to sometimes to find a faulty pot purely by taking ...

...throttle pot ) not being dead centre when you turn it on, if it happens while going along i would first check the wiring from this pot if all okay then the pot itself must be worn. Look at the speed ...

throttle pot (wigwag) is either not dead centre or the spring used is not returning the throttle lever centre, can you see the slot at the end of the throttle pot stem? it should be dead centre to you

...ECM! Thanks in advance no scan code errors told. we can't guess it ? no country told. is this TBW, throttle by wire system the service manual has all this, buy one? USA 1.8L is TBW motor drive ...