Questions & Answers for: humidity control - Page 2

I have a GE Dehumidifier 40 pint. The power to the unit is on,display shows on, I am able to adust the humidity control, but it will not cycle on. The humidity control is probably bad. Get it replaced

...a digital temperature and humitiy reader that sits on top of the a/c controls, which tells me the humidity is very low also my chapped lips, dry throat and house plants indicate that it is dry in

...humidity control in it unless it was added after the factory. The old style mechanical control is still available from the factory at 800-223-3900 PN 42241702 (ask them to double check my memory on ...

...humidity control dial for being defective. Turn the dial to maximum, and see if you have power. If you have an electrical volt meter check for power, on the input side of the humidity control. If no ...

...humidity level you set the control to, is not the amount extracted from the air. It's the level you want it to maintain. The higher the percentage level, the more humidity stays in the house. The ...

Need Humidity Controller for furnace DNAGroup 884021BS Were can I buy a 884021BS Humidity Controller?

...you need dehumidification? Put a free-standing humidity meter near the unit to check. If you still want to run the dehum, take the humidity sensor out of the line and control the unit with a

...control board issue? Verify the humidity reading with another device. Perhaps the humidity sensor is dirty or bad. Another possibility is the switching device that runs the compressor and fan is ...

...that and the displayed humidity level is higher than the one you've set as the target, then there's probably a problem with hygrostat or control unit, in which case contact service@stadlerform.com

...60AEN1-BBO. Setting it up. All fine, except the up/down humidity set control pads don't set the % humidity - nothing happens when I press them. If there is no change, the control pad is